Kingston Memory KF316C10B/8 8GB 1600MHz DDR3 CL10 DIMM FURY Beast Blue Retail
| Status: | Available |
| SKU: | 256118 |
| Vendor: | Kingston |
| MPN: | KF316C10B/8 |
| UPC: | 740617318135 |
| EAN: | NO |
|
Kingston FURY KF316C10B/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Each module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. Each 240-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows: Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS. FACTORY TIMING PARAMETERS • Default (Plug N Play): DDR3-1600 CL10-10-10 @ 1.5V DDR3-1333 CL9-9-9 @ 1.5V DDR3-1066 CL7-7-7 @ 1.5V FEATURES • JEDEC standard 1.5V Power Supply • VDDQ = 1.5V • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • Height 1.338” (34mm) w/heatsink |
|
| CL(IDD) 10 cycles |
Row Cycle Time (tRCmin) 48.125ns(min.) |